CD Tugas Akhir

Rancang Bangun Smart Charger Berbasis Mikrokontroller Atmega8

---

Increased Science Technology cause everyone wants to gain knowledge that can make the work more efficient way, for example by using a battery as a source of energy or power to produce maximum tekonologi. Then this condition requires a comfortable atmosphere because a lot of interference on one battery as the battery is often easily damaged due to poor battery charging. Based on the need for recharging the battery that comes with the security when the battery is full protection components as setting the circuit breaker on the battery has a full charge. The current flowing to the battery when the battery has been read by the ACS721 current sensor is sent to be controlled through mikrokontoler so that the flow can be controlled with auto switching components and protection as the current from the charging circuit is decided. If the flow is greater than zero then the battery will be energized to give orders ATMega8 microcontroller to provide current through the circuit driver. Then the microcontroller on the LCD display in the form of current flow, voltage and battery charge percentage. Battery voltage is always inversely proportional to the charge, it indicates the battery has dicharger. Based on a full battery of testing when a voltage of 13.6 V Keywords: Microcontroller, Sensor Flow, LCD (Liquid Crystal Display) and battery

---

Ketersediaan

Informasi Detail

Judul Seri

-

No. Panggil

07 04. 014 (0009)

Penerbit

Pekanbaru : Universitas Riau - Fakultas Teknik - Elektro D III., 2014

Deskripsi Fisik

ix, 36 hlm.; ill.; 29 cm

Bahasa

Indonesia

ISBN/ISSN

-

Klasifikasi

07 04. 014 (0009)

Tipe Isi

-

Tipe Media

-

Tipe Pembawa

-

Edisi

-

Subjek

ELEKTRO D III

Info Detail Spesifik

-

Pernyataan Tanggungjawab

DAUS

Versi lain/terkait

Lampiran Berkas

Komentar

---

Anda harus masuk sebelum memberikan komentar